|
Home | Forums | Gallery | Webcams | Blogs | YouTube Channel | Classifieds | Calendar | Register | FAQ | Donate | Members List | Today's Posts | Search |
|
Thread Tools | Display Modes |
08-06-2014, 04:58 PM | #1 |
Senior Member
Join Date: Apr 2006
Location: Central MA-Gilford
Posts: 1,411
Thanks: 308
Thanked 117 Times in 94 Posts
|
Faucet issue... Help !
Have a issue with a kitchen faucet.
It's a Delta faucet.... I am replacing the tiny springs and rubber bushings under each faucet handle. I've replaced one already but having an issue removing the handle from the other. The handle (L type handel) is held to the post by a 'tiny' Allen screw. I am using correct allen wrentch, but the screw appears to be mostly stripped in the handle hole from a previous replacement I suspect? The screw is located under handle L without much clearance, just enough for me to place the allen wrentch. About the screw possibly being stripped or partially stripped..... Any suggestions on how to remove? I'm at a loss at this point. Thanks for any suggestions ! Bigdog |
The Following User Says Thank You to bigdog For This Useful Post: | ||
Not to Worry (08-07-2014) |
08-06-2014, 05:08 PM | #2 |
Senior Member
Join Date: Apr 2004
Posts: 295
Thanks: 74
Thanked 52 Times in 25 Posts
|
Call delta. They have great support!
|
08-06-2014, 06:03 PM | #3 |
Senior Member
Join Date: Oct 2010
Posts: 2,028
Thanks: 603
Thanked 687 Times in 425 Posts
|
The hex where the wrench goes is probably stripped. Try a small flat bladed screwdriver. Sometimes you can catch the corners of the hex with the tip of the screwdriver.
__________________
It's never crowded along the extra mile. |
08-06-2014, 09:10 PM | #4 |
Senior Member
Join Date: Apr 2004
Location: North Shore, MA
Posts: 1,352
Thanks: 987
Thanked 310 Times in 161 Posts
|
If what Rusty suggested does not work, You may need to remove the whole faucet from the sink to get better access. If the hex socket is stripped, the only think that will work is to carefully drill it out. Be careful not to remove the threads. just use a drill that is slightly smaller than the internal diameter of the threaded hole. Hopefully, Rusty's trick will do the job as it is a simple solution.
Good luck! R2B |
08-07-2014, 07:06 AM | #5 |
Senior Member
Join Date: Apr 2004
Posts: 5,075
Thanks: 215
Thanked 903 Times in 509 Posts
|
Screw extractor or ez out
Go to Home Depot or your local hardware store and buy one of these.There are different types but here is one.
__________________
SIKSUKR |
Sponsored Links |
|
08-07-2014, 09:05 AM | #6 |
Senior Member
Join Date: Jun 2008
Location: Atkinson,NH/Rattlesnake Island
Posts: 163
Thanks: 325
Thanked 66 Times in 27 Posts
|
Allen Wrench
Try filing down the top of the Allen wrench. This will square off the profile of the wrench, and the bite will be optimized. Use as much pressure as you are able when you press the wrench on to the set screw. This is your last shot before getting out the drill.....
|
Bookmarks |
|
|