Winnipesaukee Forum - View Single Post

Grant · 08-30-2021, 01:13 PM

Love the rod holder and ladder guard ideas.

One thing I've always used them for is SCUBA tank holders for the car or truck.

Cut a long noodle into three equal sections. Bore, cut, or burn holes through each section at the top, middle, and bottom (a few inches from the end). Then take a length of nylon rope, tie a knot in one end the feed it through the top holes of all three sections, separating them by about 6-8 inches and keeping the pieces separated by that much with additional knots.

Tanks rest between noodle sections, and then they don't roll around!

OR you can just buy one pre-made. See photo.

08-30-2021, 01:13 PM	#2
Grant Senior Member Join Date: Jul 2002 Location: Pennsyltuckey, Tuftonboro, Moultonborough Posts: 1,485 Thanks: 337 Thanked 212 Times in 116 Posts	Love the rod holder and ladder guard ideas. One thing I've always used them for is SCUBA tank holders for the car or truck. Cut a long noodle into three equal sections. Bore, cut, or burn holes through each section at the top, middle, and bottom (a few inches from the end). Then take a length of nylon rope, tie a knot in one end the feed it through the top holes of all three sections, separating them by about 6-8 inches and keeping the pieces separated by that much with additional knots. Tanks rest between noodle sections, and then they don't roll around! OR you can just buy one pre-made. See photo. Attached Images __________________ "When I die, please don't let my wife sell my dive gear for what I told her I paid for it."