Marine Grease?
 

I need to grease both my trailer hubs, and the grease fittings on my Outdrive, can I use the same type grease for both ?

Now you're going to start trouble! I am on a ton of FB antique motorcycle pages and whenever oil comes up... wow opinions vary!

I like using Merc 2-4-C on boat stuff, but if I had to I would squirt in some good high temp wheel bearing grease. I use the premise that I would rather have the wrong oil, than no oil!

Edit note- the 2-4-C can be used in your wheel bearings.

Yes, use a good quality MARINE grease.

Here’s what I use in all my trailers.... https://www.lowes.com/pd/Lucas-Oil-P...rease/50353742

Dan

I'm assuming that this Lucas grease can be used on the Outdrive Zerk fittings, as well as the prop spline ?

Thanks Dan !

Anything that goes under water needs marine grease. But if you're buying a tube of marine grease you might as well use it everywhere on a boat, even above the water line.

Yes it can...

For the outdrive it is always best to refer to your manual. 2-4-C as mentioned is very good. I have a Volvo Penta with an exterior fitting that goes right into the gimbal bearing. Very nice feature.

Always good to check
 

According ti QuickSilver web site you are good to go! NLGI 2 approved rating.